Aaron: 847 AWHP.
Posted: Sun Sep 22, 2013 8:53 pm
so, i decided to dyno without tuning just to see where we left this season, for power. and it did pretty good i must say.
847 AWHP. 611 WTQ. and lots of tire slip on the rollers. 46+ psi, still with a small port head too
and i have pulled the plug on this season. work and weather are getting non-compliant, we only have a couple weeks left anyhow, and i figure why not. i wanted to hit it ONE MORE TIME with the sequential shifter now being back, but alas i just decided to skip it. i could quite possibly have gotten it down some more, but leaving off with 167 mph trap speed and still 9.41 is good enough.
one of the bigger changes i plan to do is an 8.8" live axle rear end and a 4-link setup. still Quattro (for now) and the ability to switch to RWD only is much easier at that point
847 AWHP. 611 WTQ. and lots of tire slip on the rollers. 46+ psi, still with a small port head too
and i have pulled the plug on this season. work and weather are getting non-compliant, we only have a couple weeks left anyhow, and i figure why not. i wanted to hit it ONE MORE TIME with the sequential shifter now being back, but alas i just decided to skip it. i could quite possibly have gotten it down some more, but leaving off with 167 mph trap speed and still 9.41 is good enough.
one of the bigger changes i plan to do is an 8.8" live axle rear end and a 4-link setup. still Quattro (for now) and the ability to switch to RWD only is much easier at that point
