The Project Pad

I picked this up the other day, and really have no need for it as I already have a spare just incase mine gets destroyed. This one is in very good shape, the only minor problem is the 2 5mm pins on the clutch side are broken. I say this is a minor issue, as they are not needed, just there from factory assembly(or so Im told). The timing pin on the engine side is in great shape. I put this in a parts washer tank last night, and scrubbed with a little scotch brite just to clean off a little dirt, and rust. Nothing major, just pretty it up a little.

tonite, I plan to to remove the broken pins(and possibly replace if I still have a pair) and machine the sureface. This will make it ready to bolt on minus a new pilot bearing. The pilot in it, seems to be in good shape, but I would still recomend replacing it. I will make sure to include the snap rings that hold it in. I can also get a new pilot bearing, but it will be a rubber seal, not viton seal like the OEM.

Im asking:
$150 shipped to lower 48,
$160 shipped to lower 48, with a new pilot bearing installed.

I will post pics shortly.

Thanks for looking

No time to do it last nite, so as is option still available.

Machine work is done. I only removed .006" to true up the face. This was done in a lathe just like factory. The broken pins were removed, and ready to install new ones if you wish. I may have a pair, but not sure. If I do find a pair, I will install them.



Thanks for looking!

don't bother reinstalling the long pins, they are useless cept for factory assembly stuff, they will just break soon anyway as they are long and weak

Any one? Am I asking too much?

Nope that's fair. Marc charges 225 or 250 I believe. Patience... :-)

chaloux wrote:Nope that's fair. Marc charges 225 or 250 I believe. Patience... :-)

Thanks Matt.

Offers? I need funds to get the Bandit on the road.

need other parts in trade?

Kuma wrote:need other parts in trade?

Not right now, unless you have have a megasquirt system you dont want lol

if i had megasquirt id be using it already

TTT

Anyone need one? Make an offer, I need to get the bandit going!

$150 delivered to AUS?

Jeychen, You have PM

Bump. Offers?

Lol I can't believe this hasn't sold. Timing can be ridiculous sometimes

Yep, I must have picked a bad time. Oh... well... If it doesnt sell, I will have 2 spares. Maybe I should machine a 60-2 setup in the side of one of them...

Bump just for the heck of it.

PM sent...

Sent from my HTC One using Tapatalk 4

SOLD!