The Project Pad

Powdercoated wrinkle black front facing IM(AAN) for b2. This was my custom one that was in my 4kq that has to use MY rail(stainless 8an in 6an out) 500OBO with rail

side mount b2 radiator(plastic tanks but new) maybe 200 miles on it. 100 obo, no fan/shroud. add 60 for shroud(plastic) and b3/b4 2 speed fan.

wg Springs yellow or red (034) 40 shipped each

AAN windage tray 40, i have one or two.

AAN supertech valve springs/retainers. 250 obo

oil filter housing, 40. have one or two

AAN crank pulley. 50 +shipping.

Aan cams make an offer.

AAN supertech valves. Bought them used, they are .5 over. 250 OBO

AAN harness made to fit into b2 chassis. 150obo NO ECU robbed the firewall grommet off it now.

MORE LATER

Head sold

Make sure to bring one of those AAN windage trays to carlisle! I guess you decided to strip down that AAN farther than you thought since I asked you about it on MG

Good luck with selling the rad and fan shroud. I have had mine listed for half that for over a year with little to no interest. I finaly have the rad sold at carlisle.

nah its all still together, i got 2. :-D

Is the radiator OEM? If so I am interested.

no, nissen plastic end tanks.

Bump for updated parts I forgot I had that I def dont need lol. Hank feel free to trade me for $ owed If anything rings your bell ;-)

cam gear and gasket set

K

hehe now it says 90% complete aan crank pulley

Hey Jim

Any pics of the harness? I'm thinking of doing an AAN swap on my UrQ. Pics of the Mani in case I don't get one from hank?

Ill snap a few later today. It was the harness that was installed in my car running. The intake you can find pics on my first page of my 07k thread if you get bored. I did steal the grommet off the harness but theyre only like 8-10 $ from audi. Just didnt wanna wait for one. ;-)

updated