The Project Pad

I am looking for a set of axles from an automatic Audi. Specifically, I need inner CV joints that are a Double Offset style as shown on the left in the picture below. The one on the right will not work for me. These came off a B4 Cabriolet, but the inner CV geometry is the same between pretty much all automatic Audis from the late 80's through the early 2000's. I *think* that older cars such as the 80, 90, 100, 200, cabriolet, etc. will be more likely to have this style CV.

Please let me know what you have! Thank you!!

Double offset have like 6 balls in them with the yoke? Or that another different kind? If so the c4 cars yes that style and we probably have a hundred, I'm sure one is then is good. No idea if the shaft is the same diameter though

Yes exactly, six balls that run in grooves in the cup which bolts to the transmission. I'll PM you!

Bump!! Still need help, this is the only thing holding me up on finishing the lifted car. Please and thank you!

PM'd ya!

Messaged you back!

I think I have the axles from my manual swap on the cab. let me check

Grillage wrote:I think I have the axles from my manual swap on the cab. let me check

That would be awesome, thank you!