The Project Pad

So everyone, who has tried to remove and especially replace these bushings, usually finds it a PTA.

So what are thoughts on cutting them in the middle and making two halves? They are held in with the tube and washers. Would it be that bad?

Greg W.

I was able to pull the bushings in with a couple sockets and some threaded rod, just lube up the bushings and keep trying.

I can do it, just pain to do.

Greg W.

No reason to cut them then.


Will cutting a bushing in half and then reinstalling it have an effect? Probably. Dont know for sure but if you can put them in without cutting them why even risk it?