Urgent WTB: B3 working odo
Posted: Wed Aug 12, 2015 12:13 pm
Racing this weekend. Looking for for someone preferably in the Northeast that can ship today so I have it on Thursday.
The Project Pad
Urgent WTB: B3 working odo
Page 1 of 1
Re: Urgent WTB: B3 working odo
Posted: Sun Aug 16, 2015 8:19 am
Found a loaner, determined all wiring was good, now seeking a permanent cluster for the rally car. Somewhere near 215k on the odo would be magic, but anything working would be great!
Re: Urgent WTB: B3 working odo
Posted: Sun Aug 16, 2015 11:57 am
looking for a a b3 80/90 cluster (120mph) or a b3 cq (160mph, trip computer/autocheck, etc) cos that a big different in the price
Urgent WTB: B3 working odo
Posted: Sun Aug 16, 2015 3:27 pm
If full cluster then CQ if just the odo and/or speedo the 80/90 will work. Thanks for the clarifying question
Update: any 20V90 cluster will do
I have 2 mostly working clusters, neither has a working odo though
Update: any 20V90 cluster will do
I have 2 mostly working clusters, neither has a working odo though
Re: Urgent WTB: B3 working odo
Posted: Sun Aug 16, 2015 8:37 pm
Just replace the gear in the odo and be done with it, they can be had off of eBay for less than $20
Re: Urgent WTB: B3 working odo
Posted: Sun Aug 16, 2015 8:39 pm
If only that was that was the problem. Motor is the issue or it would be a mute point by now.
Re: Urgent WTB: B3 working odo
Posted: Sun Aug 16, 2015 8:51 pm
cq speedometer, everything works, non bleeding trip computer, clock: $150
- DSCF6016.JPG (1.25 MiB) Viewed 19508 times
- DSCF6019.JPG (1.26 MiB) Viewed 19508 times
- DSCF6024.JPG (1.27 MiB) Viewed 19508 times
Re: Urgent WTB: B3 working odo
Posted: Wed Aug 19, 2015 12:30 pm
That's a bit fancy for my car.
Update- any 20V90 cluster will do
Update- any 20V90 cluster will do
Re: Urgent WTB: B3 working odo
Posted: Wed Aug 19, 2015 12:42 pm
Contact porschenut on MG. He is parting out and early build 90 20v.
Re: Urgent WTB: B3 working odo
Posted: Wed Aug 19, 2015 12:51 pm
groff wrote:That's a bit fancy for my car.
Update- any 20V90 cluster will do
I'm while sorting through my pile of clusters with problems last night I noticed that the clusters are marked with impulses per mile.
You probably want to match this up so that your speedometer and odometer match reality.
jack
Re: Urgent WTB: B3 working odo
Posted: Wed Aug 19, 2015 12:59 pm
groff wrote:That's a bit fancy for my car.
Update- any 20V90 cluster will do
a 90 20v cluster is exactly the same as the CQ, but few 90 didnt have the trip computer.
Urgent WTB: B3 working odo
Posted: Fri Aug 21, 2015 10:19 pm
Understood. Every cluster I've had thus far hasn't had the fancy trip. I'd rather see the fancy trip computer and nice cluster go to a member with a daily/show car versus my rally pig!
Re: Urgent WTB: B3 working odo
Posted: Sat Aug 22, 2015 7:29 am
DE80q wrote:Contact porschenut on MG. He is parting out and early build 90 20v.
Contacted, doesn't have one :/
Re: Urgent WTB: B3 working odo
Posted: Sat Aug 22, 2015 8:44 am
Re: Urgent WTB: B3 working odo
Posted: Tue Aug 25, 2015 2:02 pm
groff, you can also just swap speedometers around between clusters. I had a 90 20v beater without a working odo, and the gear wasnt the issue. The actual stepper motor was dead. I swapped in a 120mph speedo and motor from a front wheel drive 4 cylinder 80 into the 90 20v cluster and all worked accurately. So any working b3 speedo/odo can go into your cluster.