The Project Pad

I was going to throw coilovers on my 5K, but those plans got postponed so long that I ended up getting rid of the 5k before I finished them. I have however, started the coilovers again on my 20vt...I'll start a thread and do a full introduction then

These housings are coilover ready. New wheel bearings (Optima's from GAP) and machined rings that have been TIG welded right on top of the steering arm. They were etched and then sprayed with Rustoleum semi gloss black for those that care. These have the 18mm ball joints.


I'm looking to get 200 shipped (they are heavy!), but there is lots of wiggle room as I don't have a car to put them on anymore. Need cash for other projects so I'm not looking to trade. Thanks,

Richie

These are NOT UFO housings correct?

Correct. These are your standard 5k G60 housings.

They will work on a 200 20v with 200 hubs and the ball joint hole enlarged 1mm from 18mm to 19mm

in case anybody was curious....

175 shipped!

For the love! Take these away for 150 shipped!

Anyone? Dont make me put these on my beater 5k!

Hi,

Are these housings still available? Have the steering arms been relocated? Thanks!

Hi, they are indeed available. The steering arms have not been relocated, that geometry is all stock.

Richie

These are now free + shipping! I'm tired of moving them around! Rings tig welded on and new wheel bearings. Probably be around 70 bucks to ship.

Sold! Well, given away...