Page 1 of 1
Anyone have access to a mill?
Posted: Sat Aug 02, 2014 5:22 pm
by iammrfancypants
I need a triple tree on my motorcycle bored out. Swapping to newer style beefier forks. Basically if you are not bike savvy I need 4 holes bored from 37mm to 41mm. Can anyone do this local to New England? I've tried local machine/engine shops but they do not seem too interested. Trying to get this done with the least amount of downtime. I will pay for express shipping both ways. Thank you.
Re: Anyone have access to a mill?
Posted: Sat Aug 02, 2014 5:31 pm
by my2000apb
yes
jeez
haha lol
hit me up later and ill actually send you that exhaust parts info later too
Re: Anyone have access to a mill?
Posted: Sat Aug 02, 2014 7:10 pm
by iammrfancypants
my2000apb wrote:yes
jeez
haha lol
hit me up later and ill actually send you that exhaust parts info later too
I was wondering what happened to that. Did my vacuum lines all up today just need to install the new brake booster and she will be exhaust/tune limited.
I think I found a cb1100f.net member VERY close to me that is helping me with the milling work though.