The Project Pad

my2000apb wrote:im very sure the fw and ring gear are both steel

I must be thinking of a different flywheel then, good to know.

We have just been popping off the 034 ring gear and pressing on factory gears off OE flywheels with a couple of stitch welds.

We can supply them without the 6 hole ring gears as well, which would probably be fine and prevent ring gear grenade. I'd just stitch the gear on with the ol TIG

Sweet, that's good news.

Hank wrote:We have just been popping off the 034 ring gear and pressing on factory gears off OE flywheels with a couple of stitch welds.

We can supply them without the 6 hole ring gears as well, which would probably be fine and prevent ring gear grenade. I'd just stitch the gear on with the ol TIG

So hank should I swap the gear old weld the old one. I prob have a ring gear...which ones work?

I sent him one from a 7A

I put longer bolts in too so I think they pass damn near the whole way through
. i used the same bolts as the rear lower timing cover. The trip square ones.

Did u weld the ring gear while the trans was out. Did I say to much? UPDATE THIS!

Yes! Updaaaaaaaaaàate

i want a ride tomorrow!!!!!!!!!!!

wait this thing is mobile?!

https://www.facebook.com/video.php?v=94 ... nref=story

not sure if this works for people who not on faceass

Yes, it works.
Sounds sick. Need more.

I'll have a full update and juicy details on a new unintended direction the project has taken. pics and details to come. Lets just say for the ones that have a clue whats up....I got the chassis I said I was getting. it needs serious love. good thing I love this "project'. haha. at least its another 84...

So mysterious...

I have a good general idea of what is going to happen. I look forward to the actual details!

Hope you back is feeling better Jim.

ok quick teaser for those of you not on social media.... The URQ is coming out to play. The 4000s replacement shell I bought is rotted to the point it needs serious attention. Not in the cards at the moment. Itd literally take me less time to put my URQ back on the road. Pics and progress to come. I'm kinda trying to get it ready for wolfsgart. Which actually isnt too far fetched...

:-(

:/ We should of never waxed it.. lol

Very sad pics...

damn man - what did you hit?

Up a slope. Slight right. In boost. Hit sand. No saving it. :-(

That's really all Igot. I could post pics of the scene a couple days later, but you kinda had to be there sorta thing. Ha

That all sucks. Bummer about the oil.pan!

Did it puncture? I would make sure the baffles are ok, seal it up and run it.