The Project Pad

ATTENTION EVERYONE!!!

THE 20 orders have been met on PAPER!!!

I NEED EVERYONE TO PM ME (or post if you are brave) YOUR PAYPAL!!!! I WILL SEND OUT AN INVOICE IMMEDIATELY.

I am beginning the mold and engineering process tomorrow with my poly supplier!

if you did not get a pm or pm me, please let me know. I have been sending out invoices like mad!

*raises hand*

When will they be ready?

The mold itself will most likely take about 2 weeks. After that, about a week for them to send me the prototypes. Add one more day for me to test fit and verify. Then add about 1 more week for the first major shipment to arrive.

All in all, about 4-5 weeks

Still waiting on a few more of you for payments! If I somehow *again* missed sending you an invoice please smack me with a stick!

Sent.

Mold Process has started

Ok everyone!

I have determined that the v8q use M10 studs for its bushings. This is just an FYI for anyone wondering

AngryTaco wrote:Ok everyone!

I have determined that the v8q use M10 studs for its bushings. This is just an FYI for anyone wondering

you mean bolts?

It sure looks like studs on mine. It's a nut on the bottom of the subframe. Unless it's a bolt thru?

Are you coming down to Battle Born again this year? If so, are you going to bring some of your bushings with you, I might pick up a set?

Rear T44 uses a stud, correct.

A20V200 wrote:Are you coming down to Battle Born again this year? If so, are you going to bring some of your bushings with you, I might pick up a set?

I'm not planning on it this year. Too much school and work going on. I can however, ship a bunch of stuff down to Ben if you guys would like to pick them up there. No shipping charges either

Also, the mold is done and I am awaiting the prototypes.

Don't make me bust out the whip on those who haven't paid yet! You know who you are!

Prototypes have arrived today!!! I will post pictures later in a few!

Weeeee

Nice! I need to get my car off the ground and replace EVERY bushing one of these days..

WOMBAT wrote:Nice! I need to get my car off the ground and replace EVERY bushing one of these days..

Same here! My plan is to collect all the parts and do a full suspension, drivetrain mounts and bushing overhaul at once. Cannot wait!!

I've been collecting for years! Hoping to start in in a month or so

I'll be working on the fronts once this is batch is over. I hope to have the fronts done in 2 months

Grabbing the sleeving rod on Friday. Hoping to have at least the 2 installed on Sunday.

Any interest in doing a run of avant rsb bushings? I have a new pair that I'll donate to the cause. Or maybe rear toe link bushings? I dont have one of those but will pick one up if theres interest.