SOLD! 1983 URQ Project car

Buy and Sell your parts here
Post Reply
jsnpbts
Posts: 6
Joined: Mon Mar 04, 2013 11:24 pm

SOLD! 1983 URQ Project car

Post by jsnpbts »

Sold!!





I'm selling a 1983 Audi Quattro or UR Quattro to many. The car has some damage to the drivers side front fender and drivers rear fender. The car is relatively rust free with most of it being just surface rust. Great start to a 20v swap or full resto. Have a spare rear wing and the factory but damaged front left fender.
The car has been parked for 10+ years. I have attempted to get it running but the fuel system needs some attention.
Asking 10k for best offer.
Image

Image

Image

Image

Image

Image

Image
Last edited by jsnpbts on Sat Mar 09, 2019 6:37 pm, edited 2 times in total.
87 325e (2.7i)
02 BH Hippywagon (daily)

86 635csi (sold)
87 4kcsqt (sold)
User avatar
pilihp2
Posts: 1106
Joined: Fri Mar 01, 2013 2:18 am
Location: Reno, Nv

Re: 1983 URQ Project car

Post by pilihp2 »

FYI: Located in northern Nevada
-Phil
87 5ktq - 20vt
91 v8 5spd - Why?
05 S4 - Gone and very much so forgotten
14 TDI Touareg

-Terrible at responding to PM's
jsnpbts
Posts: 6
Joined: Mon Mar 04, 2013 11:24 pm

Re: 1983 URQ Project car

Post by jsnpbts »

pilihp2 wrote:FYI: Located in northern Nevada
I forgot to mention that. Thanks Boo.
87 325e (2.7i)
02 BH Hippywagon (daily)

86 635csi (sold)
87 4kcsqt (sold)
landfill
Posts: 247
Joined: Fri Mar 11, 2016 6:22 pm

Re: 1983 URQ Project car

Post by landfill »

Interested but bad timing.

I have a couple questions if
you don’t mind. Is it a clean
or branded title? Also any idea
of mileage? Any rust on the
suspension, frame, chassis, or
floor boards? If I fix the fueling
problem is the motor healthy
otherwise?

Sorry for all the questions lol..
jsnpbts
Posts: 6
Joined: Mon Mar 04, 2013 11:24 pm

Re: 1983 URQ Project car

Post by jsnpbts »

landfill wrote:Interested but bad timing.

I have a couple questions if
you don’t mind. Is it a clean
or branded title? Also any idea
of mileage? Any rust on the
suspension, frame, chassis, or
floor boards? If I fix the fueling
problem is the motor healthy
otherwise?

Sorry for all the questions lol..
No worries. The title is clean. I believe the odometer is accurate, so 190k.
There is some surface rust on the under side of the car, but I haven't found any serious rust anywhere.
the motor turns over fine, and we did get it to run with out the start for a few seconds at a time on starting fluid. That being said, I would recommend doing full services to the car before any real driving, seeing as it has been sitting a while.
87 325e (2.7i)
02 BH Hippywagon (daily)

86 635csi (sold)
87 4kcsqt (sold)
Driggs
Posts: 63
Joined: Fri Apr 08, 2016 1:27 pm

Re: 1983 URQ Project car

Post by Driggs »

Here are the pictures from the last time it was for sale.

I would be very worried about the drivers side wing under the fender.

Also there is a dent just under the passenger wiper arm hole which will be tricky to get flush.

The current drivers side front fender and door are off a Coupe GT and the front fender will need to be replaced with a proper urq one.


Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
83 urq
84 4ksq
91 200q 20v
Pair of 81 GPz 550's
74 Norton Commando

http://b2resource.com
Afterthought
Posts: 1249
Joined: Thu Jan 16, 2014 5:43 pm
Location: Bellingham, Wa

Re: 1983 URQ Project car

Post by Afterthought »

Full restoration obviously and/or candidate for a widebody , the underside actually doesn’t look too bad , I have seen worse rust wise . It looks like a lot of it was self induced .
It’s a bummer that the rockers always get dented as those are deceivingly a reaaaaal pain to make
jsnpbts
Posts: 6
Joined: Mon Mar 04, 2013 11:24 pm

Re: 1983 URQ Project car

Post by jsnpbts »

Thanks for posting more pictures!
I just posted the ones Joe had taken and sent to me.
87 325e (2.7i)
02 BH Hippywagon (daily)

86 635csi (sold)
87 4kcsqt (sold)
Afterthought
Posts: 1249
Joined: Thu Jan 16, 2014 5:43 pm
Location: Bellingham, Wa

1983 URQ Project car

Post by Afterthought »

Fyi
There was someone on quattroworld looking to get ahold of you it looks like . I would take it but I think I’m more than “over my head” with urq restorations

https://forums.quattroworld.com/quattro ... 3704.phtml


Sent from my iPhone using Tapatalk
Post Reply