WTB: Automatic axles/CV's

the german · Post by **the german** » Tue May 30, 2017 1:05 am

I am looking for a set of axles from an automatic Audi. Specifically, I need inner CV joints that are a Double Offset style as shown on the left in the picture below. The one on the right will not work for me. These came off a B4 Cabriolet, but the inner CV geometry is the same between pretty much all automatic Audis from the late 80's through the early 2000's. I *think* that older cars such as the 80, 90, 100, 200, cabriolet, etc. will be more likely to have this style CV.

Please let me know what you have! Thank you!!

chaloux · Post by **chaloux** » Tue May 30, 2017 6:09 am

Double offset have like 6 balls in them with the yoke? Or that another different kind? If so the c4 cars yes that style and we probably have a hundred, I'm sure one is then is good. No idea if the shaft is the same diameter though

the german · Post by **the german** » Tue May 30, 2017 10:16 am

Yes exactly, six balls that run in grooves in the cup which bolts to the transmission. I'll PM you!

the german · Post by **the german** » Wed May 31, 2017 11:08 pm

Bump!! Still need help, this is the only thing holding me up on finishing the lifted car. Please and thank you!

mrdeye · Post by **mrdeye** » Fri Jun 02, 2017 7:50 pm

PM'd ya!

the german · Post by **the german** » Mon Jun 05, 2017 11:14 am

Messaged you back!

Grillage · Post by **Grillage** » Mon Jun 05, 2017 4:52 pm

I think I have the axles from my manual swap on the cab. let me check

the german · Post by **the german** » Tue Jun 06, 2017 10:40 am

Grillage wrote:I think I have the axles from my manual swap on the cab. let me check

That would be awesome, thank you!

WTB: Automatic axles/CV's

WTB: Automatic axles/CV's

Re: WTB: Automatic axles/CV's

Re: WTB: Automatic axles/CV's

Re: WTB: Automatic axles/CV's

Re: WTB: Automatic axles/CV's

Re: WTB: Automatic axles/CV's

Re: WTB: Automatic axles/CV's

Re: WTB: Automatic axles/CV's