B3 044 pump install

DE80q · Post by **DE80q** » Sun Feb 21, 2016 9:40 am

I have been looking for a while now, and obviously not in the right spots. Can anyone point me in the right direction for the fittings I will need to install the 044 pump in the factory location on my 91 80Q? Thanks.

audifreakjim · Post by **audifreakjim** » Sun Feb 21, 2016 11:08 am

Are you going to run a -6 fuel line too or use stock?

DE80q · Post by **DE80q** » Sun Feb 21, 2016 11:17 am

I would like to keep the stock line for now. The pump came with a -6 adaptor, but not ready to run a whole new line right now.

DE80q · Post by **DE80q** » Wed Feb 24, 2016 9:17 pm

Can I use the fittings from the factory pump? Sorry for the dumb questions, but I don't have the car close to me, and would like to order any fittings I will need. Thanks

audifreakjim · Post by **audifreakjim** » Wed Feb 24, 2016 9:35 pm

I think the output fittings are the same. Use the check valve and banjo fittings. For the inlet, get a -8 barbed fitting.

DE80q · Post by **DE80q** » Thu Feb 25, 2016 10:07 am

Ok, so a M18 with a 1/2" Barb? Sounds easy enough.

Like this one?
http://www.ebay.com/itm/like/2914392504 ... ps&lpid=82

B3 044 pump install

B3 044 pump install

Re: B3 044 pump install

Re: B3 044 pump install

Re: B3 044 pump install

Re: B3 044 pump install

Re: B3 044 pump install