Urgent WTB: B3 working odo

groff · Post by **groff** » Wed Aug 12, 2015 12:13 pm

Racing this weekend. Looking for for someone preferably in the Northeast that can ship today so I have it on Thursday.

groff · Post by **groff** » Sun Aug 16, 2015 8:19 am

Found a loaner, determined all wiring was good, now seeking a permanent cluster for the rally car. Somewhere near 215k on the odo would be magic, but anything working would be great!

varia · Post by **varia** » Sun Aug 16, 2015 11:57 am

looking for a a b3 80/90 cluster (120mph) or a b3 cq (160mph, trip computer/autocheck, etc) cos that a big different in the price

groff · Post by **groff** » Sun Aug 16, 2015 3:27 pm

If full cluster then CQ if just the odo and/or speedo the 80/90 will work. Thanks for the clarifying question

Update: any 20V90 cluster will do

I have 2 mostly working clusters, neither has a working odo though

RS4Tech · Post by **RS4Tech** » Sun Aug 16, 2015 8:37 pm

Just replace the gear in the odo and be done with it, they can be had off of eBay for less than $20

groff · Post by **groff** » Sun Aug 16, 2015 8:39 pm

If only that was that was the problem. Motor is the issue or it would be a mute point by now.

varia · Post by **varia** » Sun Aug 16, 2015 8:51 pm

cq speedometer, everything works, non bleeding trip computer, clock: $150

: DSCF6016.JPG (1.25 MiB) Viewed 19513 times

: DSCF6019.JPG (1.26 MiB) Viewed 19513 times

: DSCF6024.JPG (1.27 MiB) Viewed 19513 times

groff · Post by **groff** » Wed Aug 19, 2015 12:30 pm

That's a bit fancy for my car.

Update- any 20V90 cluster will do

DE80q · Post by **DE80q** » Wed Aug 19, 2015 12:42 pm

Contact porschenut on MG. He is parting out and early build 90 20v.

Sparkyjack · Post by **Sparkyjack** » Wed Aug 19, 2015 12:51 pm

groff wrote:That's a bit fancy for my car.

Update- any 20V90 cluster will do

I'm while sorting through my pile of clusters with problems last night I noticed that the clusters are marked with impulses per mile.
You probably want to match this up so that your speedometer and odometer match reality.

jack

varia · Post by **varia** » Wed Aug 19, 2015 12:59 pm

groff wrote:That's a bit fancy for my car.

Update- any 20V90 cluster will do

a 90 20v cluster is exactly the same as the CQ, but few 90 didnt have the trip computer.

groff · Post by **groff** » Fri Aug 21, 2015 10:19 pm

Understood. Every cluster I've had thus far hasn't had the fancy trip. I'd rather see the fancy trip computer and nice cluster go to a member with a daily/show car versus my rally pig!

groff · Post by **groff** » Sat Aug 22, 2015 7:29 am

DE80q wrote:Contact porschenut on MG. He is parting out and early build 90 20v.

Contacted, doesn't have one :/

varia · Post by **varia** » Sat Aug 22, 2015 8:44 am

http://www.motorgeek.com/viewtopic.php? ... ead#unread

Instrument Cluster - $60

dana · Post by **dana** » Tue Aug 25, 2015 2:02 pm

groff, you can also just swap speedometers around between clusters. I had a 90 20v beater without a working odo, and the gear wasnt the issue. The actual stepper motor was dead. I swapped in a 120mph speedo and motor from a front wheel drive 4 cylinder 80 into the 90 20v cluster and all worked accurately. So any working b3 speedo/odo can go into your cluster.