Taco's Tig Welding....prepare for epicness

[AngryTaco]

Little late posting these but I did pick up my Miller 210 Tig finally a couple weeks ago. After practicing, these are the results so far. I'm updating the motor mount plate thread and taking orders.

These first two pics were going vertically up

[ringbearer]

oohhh, diamond plate dress up parts for your 20v swap into the Dodge?

lol, big improvement!

[AngryTaco]

Yeah yeah.....just wait till that dodge is back on the road. You wont be laughing then lol!!

[uberaudi]

Looks like it's getting there, nice work. What thickness aluminum are your mounts going to be? Welding thicker aluminum requires a ton of heat!

[AngryTaco]

They will be same size as the steel ones (1/4"). Since the welding is for a non load bearing piece, I wont need full penetration. Either way, I am striving for a perfecr weld and will be pre-heating with the oxy-ace torch

[Uncle Helmut]

I love TIG welding! It relaxes me! People do Sudoku, Crosswords, knit...etc. I weld! LOL

[Afterthought]

I have a long way to go on this but have spent quite a bit of time practicing. Do you run the welder in pulse mode?
I need to get the timing better of moving the puddle forward and dipping the rod.

[AngryTaco]

Ive played with the pulse but these pictures are straight pedal. Pulse mode requires a good rythem which I havent got down yet.

[dana]

requires a good rythem which I havent got down yet.

white boy.

[audifreakjim]

Lol