Wrench size question -- AAN

[PRY4SNO]

What size wrench do I need for supply/return lines where they go from the oil cooler the filter housing, and AC hard lines at the compressor?

I know my 24 mm doesn't work, and my small adjustable wrench just barely maxes out so I'm guessing 26mm. Just want to make sure when I drop by the store tomorrow I grab the right one.

Thanks!



PS

If there's a thread with a short list of wrench sizes and tq values I'd appreciate the link! Am working with a 90/Cq Bentley as the UrS4/100 manual is a bit steep for me at the moment.

[Toph]

I should have some time today to put a set of calipers on the oil cooler lines, but the AC is long gone.

[PRY4SNO]

Thanks for the offer but I picked up a set of adjustable wrenches today since we got shut down at work today. Who knew you couldn't lift with cranes in 120 km/h wind gusts!

27 mm for the oil cooler nuts at the filter housing.

30 mm and 32 mm at the AC compressor.