60-2 rear crank seal

gtn116 · Post by **gtn116** » Sun Jan 12, 2014 8:39 pm

60-2 rear crank seal, installed on a motor with the plug cut off (to go out a hole in the bellhousing). The kit is $275 from Marc. I want $250 OBO. Also have an ABY intercooler with some pipes welded on it. Make an offer on it.

AngryTaco · Post by **AngryTaco** » Tue Jan 14, 2014 7:59 pm

Would you considering selling just the VEMS?

chaloux · Post by **chaloux** » Tue Jan 14, 2014 8:02 pm

AngryTaco wrote:Would you considering selling just the VEMS?

AND SO IT BEGINS!

gtn116 · Post by **gtn116** » Tue Jan 14, 2014 8:10 pm

You were just the guy I was hoping to rope in. ;-) I would prefer to get rid of the vems, harness and rear crank seal/trigger wheel together because they're pretty useless without each other.

AngryTaco · Post by **AngryTaco** » Wed Jan 15, 2014 12:57 am

chaloux wrote:
AngryTaco wrote:Would you considering selling just the VEMS?
AND SO IT BEGINS!

Why does all the good stuff pop up when I'm spending $300 on a damn rollpan for my Dodge this week!?

Anyways PM sent to OP

60-2 rear crank seal

60-2 rear crank seal

Re: Ghetto 20vt, VEMS and harness

Re: Ghetto 20vt, VEMS and harness

Re: Ghetto 20vt, VEMS and harness

Re: Ghetto 20vt, VEMS and harness